What Ctrl+Z Does in the Huawei VRP CLI
Short answer
A Ctrl+Z returns the VRP CLI from any configuration view directly to the user view, exactly like the return command.
Question
Key Takeaways
The question tests VRP view-navigation shortcuts, and the trap is confusing the single-level exit of quit with the all-the-way return of Ctrl+Z.
In Huawei VRP, Ctrl+Z (equivalent to the return command) jumps from any configuration view back to the user view in one step, which is answer A on this H12-811 question.
Common mistake: Option C is the tempting pick, but it limits Ctrl+Z to the system view; the key also works from interface, ACL and any deeper view, so only A states the full behaviour.
Expert Analysis
How the VRP CLI is layered
Huawei's VRP organizes the command line into a hierarchy: you start in user view (<Huawei>), enter system view ([Huawei]), and from there descend into interface views, VLAN views, ACL views and so on. Navigation out of that hierarchy is governed by a small set of keys and commands, and each one has a precisely defined scope.
Where Ctrl+Z takes effect
Ctrl+Z is a global return: from wherever you currently sit in the hierarchy it jumps straight back to user view in one step, without visiting the intermediate levels. It is functionally identical to typing the return command at the prompt. As the community explanation puts it, "Ctrl+Z immediately returns the user to the User View from any view, regardless of how deep in the configuration hierarchy the user currently is. This is equivalent to typing the return command." So the mechanism is: keystroke → VRP discards all open configuration contexts → prompt returns to <Huawei>. This makes option A the correct choice.
Why the near-misses fail
Option C ("from the system view") describes only the shallowest case; Ctrl+Z also works from interface, ACL or any other deeper view, so C is incomplete rather than wrong-in-principle. Option D ("exits the current view") is the behaviour of the quit command, which backs out exactly one level — if you are three levels deep, three quit commands are needed. Options B and E are simply quit applied inside an interface/console view; note also that E is redundant with B, since a console port is configured through an interface view.
Exam takeaway
Read the scope words carefully: "any view" versus "the system view" versus "the current view". Single-level exit = quit; full reset to user view = Ctrl+Z/return.
Exam Strategy
When a question names a key or command, first identify its scope: does it affect one level, the current view, or the whole hierarchy? Map each option to a specific VRP command (quit, return, Ctrl+Z) and eliminate any option that is a narrower restatement of another — here C is a subset of A, and B/E are subsets of D. Only the option describing the complete behaviour of the key earns the mark.
Frequently Asked Questions
Is Ctrl+Z the same as typing return in VRP?
What is the difference between Ctrl+Z and quit in VRP?
Which view do I land in after pressing Ctrl+Z in a Huawei interface view?
Community Votes
100% of anonymous learners picked answer A. Votes are pick records left by other test-takers — they are not the verified answer.
Discussion 2 contributions
Compiled from public community threads and reader submissions, lightly edited for clarity. Handles and vote tallies are shown as recorded, and comments reflect the views of individual contributors.
From public community threads 2
-
Fmoura17 👍 1 Answered AThe correct answer is A. A. Returns from any view to the user view ✅ Ctrl+Z immediately returns the user to the User View from any view, regardless of how deep in the configuration hierarchy the user currently is. This is equivalent to typing the return command.
-
ButcherCapybara 👍 1 Answered AReturns from ANY view to user view
Reader comments & corrections
No reader corrections yet — spotted an error or have a note? Share it below.