Purpose of Webex Dial Plan Locations

Webex Calling Configuration

What is the purpose of configuring locations in a Cisco Webex dial plan?

to specify the maximum bandwidth to allocate per Webex call
to choose how many Webex data centers to use for redundancy
to conserve bandwidth by selecting the closest data center
to allow the use of an existing PSTN provider for local calls Source Reference Answer

Community Votes

100%

100% of anonymous learners picked answer D. Votes are pick records left by other test-takers — they are not the verified answer.

Community Insight

This question tests the distinction between Webex 'Locations' and traditional CAC 'Locations'. The common trap is assuming locations manage bandwidth (CAC), whereas they actually manage routing and PSTN selection.

Cisco Webex locations group users and devices by geographical site to define dialing behaviors and PSTN access. The community consensus confirms that locations are used to route calls through existing PSTN providers rather than for bandwidth control.

Community Discussion (3 comments)

G0y0 👍 1 Selected: D

Webex Locations are settings configured in the Webex Control Hub for Webex Calling that allow you to group together any users and devices using the calling feature that have the same dialing behaviors based on their location. This can be configured based on any location that will have a Local Gateway assigned to it. A. and C. are incorrect since the concept of Webex Location is different of that on-premise CUCM Location. B. is incorrect. Webex Location just connect to a Webex Calling SBC using a Local Gateway with a trunk, it does not have to do with how many datacenters are in the Webex Cloud.

fa2451d 👍 1 Selected: D

Should be D

Bazant 👍 3 Selected: D

NOT A. In Webex dial plan there is a concept of location, but it does not have any CAC capabilities, Webex Calling locations concept group together devices or users sharing the same geographical location (address) or sites, PSTN access (on-prem or cloud connected PSTN), main number, site code, PSTN steering digit (PSTN Access Code) etc. Based on the above correct answer is D https://community.cisco.com/t5/collaboration-blogs/demystifying-webex-calling-dial-plan-and-call-routing/ba-p/4949091

Comments & Corrections

No comments yet — spotted an error or have a note? Share it below.

Expert Analysis

Why the Answer Is Correct

Configuring a location in Cisco Webex Calling allows administrators to group users and devices based on their physical or logical site. This grouping enables specific dialing behaviors, such as assigning a local PSTN gateway or using a PSTN steering digit for local calls. Therefore, the primary purpose is to facilitate the use of an existing PSTN provider for efficient local call routing.

Why the Other Options Are Wrong

Options A and C describe features associated with Call Admission Control (CAC) or bandwidth management, which are not handled by Webex Locations. Webex Locations do not restrict bandwidth per call; instead, they focus on addressing and routing logic. Option B refers to data center redundancy, which is managed by global load balancing and high-availability configurations, not by individual location settings.

Community Comment Notes

Comment [1] clarifies that while traditional Cisco Unified Communications Manager uses locations for CAC, Webex Locations serve a different purpose: grouping devices/users by address/site for PSTN access and dialing plans. Comment [2] reinforces that locations allow configuring local gateways and dialing behaviors, explicitly ruling out bandwidth allocation (A) and data center selection (C).

Official Reference

https://help.webex.com/en-us/article/nq9z7x0/Webex-Locations-in-Webex-Control-Hub

Exam Strategy

Always distinguish between legacy on-premise concepts (like CAC bandwidth limits) and cloud-native implementations (like Webex Locations for routing). When asked about 'locations' in Webex Calling, think 'routing/PSTN assignment' rather than 'bandwidth/QoS'.

Related Analysis

← Back to 350-801 Study Guide