Configure and verify Layer 2 discovery protocols (Cisco Discovery Protocol and LLDP)
6 practice questions under this official exam objective (200-301), each with the answer key, an option-by-option explanation and instant feedback.
Questions under this objective
6 total · page 1 of 1CDP Behavior When an Interface Has No IP Address
This page examines Cisco Discovery Protocol operation when the CDP-enabled interface of an adjacent device has no IP address configured. Cisco's own C
LLDP Configuration on Single Interface in Multivendor Network
This CCNA 200-301 question tests configuring an industry-standard neighbor discovery protocol (LLDP) on just one interface of a multivendor network ca
Two Reasons to Use CDP: Native VLAN and Layer 2 Verification
Cisco Discovery Protocol (CDP) is a Layer 2 neighbor-discovery protocol; the two valid uses here are obtaining VLAN information from directly connecte
Is LLDP Configured in Global Configuration Mode?
LLDP (IEEE 802.1AB) is a vendor-neutral Layer 2 discovery protocol enabled on Cisco devices with the global lldp run command. This page explains why o
Multi-Vendor Network Discovery Protocol Configuration
This question addresses the selection of Layer 2 discovery protocols for a multi-vendor environment, establishing that LLDP is the standard choice ove
Which command configures an LLDP delay time of 5 seconds?
Identify the correct Cisco IOS command to configure the LLDP reinitialization delay time. This guide clarifies why the 'lldp reinit' command is used t